Description

Kenwood TS-530S HF Trans. Capacitor Replacement Kit This is a complete electrolytic capacitor replacement kit (except the 100uf/500V cans - check my "view other items" for these caps) for the Kenwood TS-530S transceiver. The TS-530S is truly a collector's item for the vintage ham radio enthusiast and represents one of the best of the '80's in HF gear. Electrolytic capacitors have a design life span which one has to recognize if the intent is to keep your TS-530S running for a long time to come. Electrolytics over time change value due to leakage, electrical stress, heat exposure etc., and can be very annoying to trouble shoot especially when intermittent. There are 86 small electrolytics used in the TS-530S so for those who like probability calculations, figure out the failure rate possibility for capacitors that already have 25+ years of service! In all cases the capacitors have been replaced with the exact value of the original, but in many cases I was able to take advantage of smaller modern day components increasing the voltage rating of the replacement unit. Technical Notes: ** Included in the kit is an installation guide to help those along who might feel a bit nervous doing this type of board work. ** There is no re-tuning of the radio required as the capacitors being changed are power supply related, or audio coupling/decoupling. Minor adjustment of the VOX controls may be required when new capacitors are installed. ** Installation Time is approximately 4 hours from start to finish for an experienced technician. For all others just take your time and enjoy. Its a fun project. The kit is comprised of the following capacitors (86 in all):