Description

Product Description: Can tune to the original non-resonant antenna by adding the appropriate inductance or capacitance so that the radio can work properly. The original resonant antenna, the antenna has changed due to outside influences, the SWR can be amended. Can be used as a band-pass filter, the emission can reduce unnecessary radiation outside the band, the cross-modulation and interference-band receiver can be reduced again. Days tune kit comes with the standing wave directions, using a T-type topology network, shortwave 1-30MHz, can withstand the transmit power of 15W, the tuning range of approximately 40-300 ohms, can be very convenient for QRP communication, to ensure high efficiency radio transceiver in communication, but also allows you to fully enjoy the fun of DIY. This kit requires some soldering electronic technology, will recognize the device, it will weld, the basic need debugging, as long as careful assembly according to package instructions can succeed. This kit welding, making easy to understand, easier to learn, easy to use. Comes with standing instructions, Q9 type interface (such as the need to be self to M-type interface), using T-topology networks, QRP facilitate communication with the low-power transceiver (shoes, frogs, octopus, etc.) used to make transceiver and antenna valid match, meet your emission requirements, ensure a highly efficient radio communications. Key Features of this manual antenna turner: Days when exposed to direct transfer power: Day tune tuning the input power: Tuning indication: LED display Interface: Q9 type Operating frequency: 1-30MHz Antenna Interface: Q9 type Match the antenna impedance range: about: 30 ~ 300Ω Carrying RF power: less than 15W Tuning required RF power: less than 3W This kit includes the original as follows: A waterproof sealed box Stickers (used to determine the position of the transfer hole) 1 Q9 Block (lug) 2 Ordinary wire segment Variable capacitor 2 2 small knob 0.25 countersunk head screws (for fixed variable capacitor) 4 The 0.25 head screws 2 0.3 gasket 4 0.3 nut 2 Multi-knife switch (12 stalls) a A large knob T106-2 the toroid (red) 1 0.5 enameled wire, Section 1, A circuit board (standing wave indicator) A stall switch The red light emitting diode 1 51 ohm 2W resistor 3 FT37-43 toroid (Black) 1 1K resistor (light-emitting diode current limit) a 1N60 1 0.1u capacitor 1 Contact us Return Policy Feedback Contact us For anything problem about product, price, shipping or order status, pleasecontact us via eBay message.Just contact us using the "Ask the seller a question" link on eBay. We expect positive feedback and 5 scores DSR from you. Return Policy We believe our items are so outstanding. We are convinced you will be happy with your Purchase. If you do not satisfy with our items. Please simply return to us within 30 Days in original condition. Just pay for the returned postage. Then we can issue full refund to you after the returned item arrived at our warehouse. Please include your eBay ID and item number with any email requests. Feedback * When you satisfied with our product and services please leave us positive feedback. * If you have got the package, please confirm "Delivery on time" For us. * If a problem occurs, contact us immediately with any email request. * Just contact us using the " Ask the seller a question" link on eBay. Your Satisfaction is our Priority. Our goal is to make all our customers as happy as possible while shopping with us.