Description

Offering a circuit extender board for the Atlas 180/210/215/350 in KIT FORM. This board, close in fit and form to the original Atlas component, is used to extend the plug-in boards so they can be serviced and/or repaired. Boards are traced, fitted and edge connector mounted. Builder needs only to solder remaining edge connector connections to the printed circuit board. Th is KIT includes the following boards: One 22 X 1 ( 22 conductors on one side for a total of 22 conductors) 3 1/2 inches in height. One 22X2 right angle edge connector adapter. (Note: This is to allow for a right angle insertion of the board to allow for the Atlas 215 filter board to be adjusted. The third photo shows the adapter before installation on the main board. The forth photo shows the adapter installed on the basic extender board. The fifth and sixth photos shows the extender with adapter extending the far right board at a right angle allowing adjustment of the board just to the left. (Filter board?) It has been reported to me that in order to extend all Atlas 22X1 boards a board without the 'L' portion attached is needed. Please call or write if more information is needed on this. Note for non-USA buyers: For some reason there is a group of countries eBay will not allow me to sell and ship to through eBay. I would like to suggest going to the HP Groups.io internet forums for help. Many there have this extender and may be willing to sell or loan the one they have. Otherwise check back later. I am continuing to try to get this resolved with eBay. TNX & 73 John WA1ESO